Introduction of the type of cabinet glass door edging machine

[China Glass Net] The general technical requirements for cabinet glass door panel glass are: glass thickness 2-5mm. After grinding the finished product, the upper chamfer slope is wider and the polishing brightness is very high. The flat edge cannot be completely covered because the invisible frame is completely polished. The requirements are higher, the lower chamfer is not exposed, and the purpose of edging is to avoid injury during the use of the glass, so there is no polishing requirement. The dimensional error of the finished glass is required to be controlled within 0.2 mm.

The standard cabinet glass special edging machine is a standard cabinet type special edging machine which is improved by the mature machine type glass edging machine for the processing technology of the cabinet panel glass. The machine grinding wheel is configured as: upper chamfering Three grinding wheels, two grinding wheels on the flat side and one grinding wheel in the lower chamfer. The grinding wheel of the machine can realize the wide width of the upper chamfered bevel, the polishing effect is good and stable, the flat edge is finely polished and the lower chamfer is polished and polished. The purpose is ideal for cabinet panel edgers.

The economical cabinet panel glass special edging machine is an economical cabinet panel special edging machine which is improved by the mature model for the process requirements of the cabinet panel glass. The machine grinding wheel is configured as: upper chamfering two grinding wheels, flat A grinding wheel is arranged on each side and the lower chamfer, which can achieve the purpose of upper chamfering edge polishing, flat edge and lower chamfering fine grinding, and is an ideal choice for cabinet panel glass edger.

The ideal cabinet glass special edge grinding machine is a new type of cabinet edge special edge grinding machine specially developed for the process requirements of cabinet panel glass. The general process requirements for cabinet panel glass are: glass thickness 2-5mm. After grinding the finished product, the upper chamfered slope is wider and the polishing brightness is very high. The flat edge cannot be completely covered because the invisible frame is not covered, so the polishing requirement is high. The corners are not exposed, and the purpose of edging is to avoid injury during the use of the glass, so there is no polishing requirement. The dimensional error of the finished glass is required to be controlled within 0.2 mm. In response to the above requirements, the grinding wheel is equipped with four grinding wheels with upper chamfering, three grinding wheels with flat sides and one grinding wheel with lower chamfering. It satisfies the realization of large chamfering and high-precision polishing, fine polishing of flat edges and falling down. The purpose of fine edging of the corners. In the control of dimensional accuracy, this model has added a linear guide type reverse positioning device, which effectively guarantees the dimensional accuracy of the edging, and is an ideal choice for the glass edging of the cabinet panel!

100% Polyester Microfiber

100% Polyester,100% Polyster Microfiber Bedsheet,100 Polyester Microfiber Sheets,100% Polyster Microfiber Bedsheet

ZHEJIANG HUIDE NEW MATERIAL CO.,LTD , https://www.zjhuide-microfiber.com